Headlamp Range Control Positioning Motor, Hella

Headlamp Range Control Positioning Motor, Hella

Removing

• If adjustment motors are removed and installed or replaced, headlamp adjustment must be checked and headlamp must be adjusted if necessary.

• Illustrations depict replacement of Headlight beam adjusting motor at right headlamp.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp. Refer to=> [ Headlamps ] Headlamps.

- Rotate cover cap - 1 - in - direction of arrow - and remove it.





- Disconnect harness connector - 2 - of headlamp beam adjusting motor - 1 -.





- Turn headlamp beam adjusting motor - 1 - in - direction of arrow A - and pull out slightly from mount - 2 -.





- Move headlamp beam adjusting motor - 1 - so that ball head - 3 - can removed from Headlamp Beam Adjusting Motor in - direction of arrow B - out of ball head mount - 4 -.

- Remove headlight beam adjusting motor out of headlight housing.

Installing

Install in reverse order of removal, noting the following:

- Insert headlamp beam adjusting motor ball head - 1 - carefully into ball head guide - arrow -.





CAUTION!
When installing the cover cap, make sure the cap is properly seated. It is destroyed by ingress of water into headlamp.

- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary