Climatic with A/C Control Module Controls

Climatic with A/C Control Module Controls

Removing

• The controls consist of two separable housings. Before removing controls, bring rotary buttons into the following position:

• Heater control to "cold"

• Blower to "0"

• Air flow direction to "footwell"

- Remove radio





- Unscrew screws - 2 - (4.2 x 45) and - 3 - (4.2 x 16) and remove controls - 1 - from center console.

Tightening specification for screws - 2 - and - 3 -: 1.5 ± 0.2 Nm





- Disengage harness connector release catch - A - by pulling in direction or arrow - 1 -.

- Disengage harness connector release catch - B - to connector - arrow 2 - and disconnect connector - C -.

- Disengage harness connector release catch - D - and disconnect connector - D -.

Installing

Installation is performed in reverse order of removal, make sure when doing so that the rotary buttons have the same position as when removing.