Selector Mechanism Cover and Circuit Board

Selector Mechanism Cover and Circuit Board

Removing

- Remove selector lever handle => [ Selector Lever Handle ] Selector Lever Handle.

- Pull up pull-rod and place selector lever in "P" with pull rod pulled up.

- Switch ignition off.

- Remove center console.

- Disconnect harness connector - 1 - from circuit board.





- Pull harness connector out of hole - arrow - in bracket - 2 -.

- Carefully pry off retaining tabs - arrows - (qty. 4).





• If retaining tabs - arrows - are damaged, cover must be replaced completely.

- Remove complete shift mechanism cover upward.

- Remove circuit board from mounts on frame - arrows -.





Installing

• When installing circuit board, make sure that the terminals are not damaged and circuit board is not bent.

- Install circuit board on to mounts on frame - arrows -.





- Connect harness connector - 1 - of circuit board.





- Clip harness connector into hole - arrow - in bracket - 2 -.

- Carefully place cover on shift mechanism and lock with retaining tabs - arrows - (qty. 4).





• If retaining tabs - arrows - are damaged, cover must be replaced completely.

- Install center console.

- Install selector lever handle => [ Selector Lever Handle ] Selector Lever Handle.