Dual Mass Flywheel

Dual Mass Flywheel

Special tools, testers and auxiliary items required

• Flywheel retainer (3067)

Removing

CAUTION!
To prevent damage to the dual mass flywheel when removing, do not remove the bolts - B - using an air powered or impact wrench. Remove the bolts by hand only.

- Mark the dual mass flywheel to the engine.

- Rotate the dual mass flywheel - A - so that the bolts - B - are centered with the holes - arrows -.





- When removing the bolts - B -, make sure that the bolt head does not contact the dual mass flywheel - arrows - and thereby cause damage when turning it further.

- Insert the (3067) into the hole in the cylinder block - B -.





- Remove the dual mass flywheel bolts by hand.

Installing

• Tightening specifications, refer to --> [ Sealing Flange and Dual Mass Flywheel Assembly Overview ] Sealing Flange and Dual Mass Flywheel Assembly Overview.

Install in reverse order of removal. When doing this note the following:

- Install using new bolts.

- Insert the (3067) into the hole in the cylinder block - A -.