Shifter ASMT: Description and Operation

Selector Mechanism Assembly Overview





1 Shift cover with knob

• Do not remove knob if not necessary. For emergency release, only cover must be removed --> [ Selector Lever Emergency Release ] Service and Repair.

• In right illustration: Before removing knob, pull button past pressure point and secure using cable tie or suitable wire. This prevents button from being pushed into knob accidentally.

2 Selector lever and selector mechanism

• With Shift Lock Solenoid (N110)

• Manual release --> [ Selector Lever Emergency Release ] Service and Repair.

• Short description for removal and installation:

- Remove center console.

- Remove cable from transmission --> [ Selector Lever Cable ] Removal and Replacement.

- If necessary: Disconnect or remove

- Remove heat shield beneath vehicle.

- Adjust selector lever cable after installing --> [ Selector Lever Cable, Adjusting ] Adjustments.

3 Bolt with spring

• 3 Nm

4 Pin

• Removing --> [ Selector Lever Cable ] Removal and Replacement

• Do not grease

5 Securing plate

• Always replace after removal

6 Nut

• 9 Nm

• Qty. 4

7 Shift housing

• With seal

8 Lock washer

• Always replace after removal

9 Lock washer

• Always replace after removal

10 Selector lever cable

• Do not grease cable.

• Removing and installing --> [ Selector Lever Cable ] Removal and Replacement

• Checking --> [ Selector Lever Cable, Checking ] Procedures

• Adjusting --> [ Selector Lever Cable, Adjusting ] Adjustments

11 Hex bolt with washer

• 8 Nm

• Qty. 4