Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Drift (T10060 A)

Removing

- Remove insulation pan.

- Mark direction of rotation of ribbed belt.

- Pivot tensioning element in direction of the arrow to release the tension on the ribbed belt.





- Align holes - arrows - and secure tensioner with the locking pin (T10060 A).





- Remove ribbed belt.

Installing

Install in reverse order of removal, noting the following:

• Before installing ribbed belt, the generator and A/C compressor must be securely installed.

• Note previously marked direction of belt rotation and be sure that it is seated correctly on pulley.

After completing repairs always:

- Start engine and check running belt.