Slave Cylinder with Release Bearing

Slave Cylinder with Release Bearing

• The clutch slave cylinder and the release bearing are a single unit and are replaced together.

Removing

• Remove the transmission.

- Pull the circlip - 2 - up using a screwdriver or a pointed tool and remove the breather assembly - 4 - from the slave cylinder - 1 -.






- Remove the bolts - arrows -.






- Remove the clutch slave cylinder and the release bearing - A -.

Installing

Installation is performed in the reverse order of removal while observing the following:

• The slave cylinder bolts may only be tightened in small increments.

Otherwise, there is the danger that the tabs for the bolts could break off.

- Install and tighten the slave cylinder with release bearing bolts => [ (Item 4) Bolt ] Clutch Release Mechanism Overview.

.

- Check the O-ring - 3 - on the clutch slave cylinder for damage.






- Install the breather assembly - 4 - on the connection on the clutch slave cylinder - 1 - until the circlip - 2 - clicks into the place.

- To check, pull on the breather assembly.

• Install the transmission.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] 02Q Transmission.