Charge Air Pipe from Noise Generator

Charge Air Pipe from Noise Generator

Removing

- Remove the cover for the intake air duct; disengage the side clips to do so - arrows -.






- Unclip the air duct from the lock carrier air duct, disengage the clips to do so - arrows -.






- Remove the air duct and the intake air duct.

- Open the latch - 1 -, unclip the fuel lines - 2 - and remove the bolts - 3 -.






- Loosen the hose clamp - arrow - and remove the charge air guide.






Installing


The charge air pipe clamps must be tightened to 5.5 Nm. An insufficient or excessive tightening torque can cause the charge air hose to come off the charge air pipe while driving.

Install in reverse order of removal. When doing this note the following:

• Hose connections and charge air system hoses must be free of oil and grease before installing. Sealing ring and sealing surfaces must only be lightly oiled with connector couplings. Refer to => [ Charge Air Hose and Pipe, Disconnecting and Connecting ] Charge Air Hose and Pipe, Disconnecting and Connecting.

• Install only approved clamps for securing hose connections.

• Charge air hose connecting and disconnecting, refer to => [ Charge Air Hose and Pipe, Disconnecting and Connecting ] Charge Air Hose and Pipe, Disconnecting and Connecting.