Clutch Release Mechanism Overview

Clutch Release Mechanism Overview





1 Transmission

2 Input Shaft Seal

• Replacing, refer to => [ Input Shaft Seal ] Input Shaft Seal.

3 Slave Cylinder with Release Bearing

• One component and can only be replaced together.

• Do not wash the bearing, just wipe it off.

• If the bearing is noisy, replace it together with the slave cylinder.

• Divided supply line on some slave cylinders, refer to.

• Removing and installing, refer to => [ Slave Cylinder with Release Bearing ] Slave Cylinder with Release Bearing.

4 Bolt

• 12 Nm, without locking compound (slave cylinder with metal housings only).

• 15 Nm, with locking compound.

• Always replace

• Quantity: 3

• Carefully tighten diagonally in small stages so that the slave cylinder bolt eyelets do not break off.

5 O-ring

• Installed onto the line connection.

• Install with brake fluid.

• Allocation, refer to the parts catalog.

Slave Cylinder - A - with Divided Supply Line





The supply line is divided in this location - arrow - on some slave cylinders

Allocation, refer to the parts catalog.