Coolant Pump Driveshaft Seal

Coolant Pump Driveshaft Seal

Special tools, testers and auxiliary items required

• Thrust Piece (T10353)

Removing

- Remove the coolant pump toothed belt. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

- Firmly press a screwdriver - 1 - into the surface of the seal - 2 -- arrow B -.





- Pry out the seal - arrow A -.

Installing

- Clean the running and sealing surface.

- Lubricate the sealing surface of the balance shaft - 2 - with transmission oil.





- Push the seal - 1 - onto the balance shaft.

• "Luftseite" or ("Outside") - arrow - must be readable from the outside.

- Install the (T10353) onto the seal - 1 - and press it into the cylinder block all the way with the bolt - 2 -; when doing this, do not bend the seal.





- Install the coolant pump toothed belt. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

The rest of the installation follows the reverse of the removal procedures.