Plastic Relay Lever

Plastic Relay Lever

From 03.07 - relay lever is plastic





• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.

This prevents damage to the selector cable.






- Pull the locking mechanism all the way forward in the - direction of arrow 1 - and then unlock to the left in the - direction of arrow 2 -.

- Press the relay lever forward (in the - direction of arrow 3 -).

Relay lever with tab - arrow 1 - (see illustration N34-10903):

- Press the tab - arrow 1 - down to the stop and remove the relay lever together with the cable retainer. Move it in the operating direction when doing so.

Relay lever with clip - arrow 1 -:





- Remove the clip - arrow 1 - and the relay lever together with the cable retainer.

Continuation for all:

The cable retainer must be behind the latch - arrow 2 -.

• The cable retainer may only be removed with the relay lever removed. Refer to => [ Removing the selector cable retainer from the plastic relay lever. ].

• Lubricate the bearing areas and sliding surfaces when installing.

- Press the cable retainer on the relay lever. Refer to => [ Installing the cable retainer ].

- Insert the relay lever together with the cable retainer as far as the stop.

Relay lever with tab - arrow 1 - (see illustration N34-10903):

• The tab - arrow 1 - secures the relay lever.

• Make sure it engages securely.

• The cable retainer must be behind the latch - arrow 2 -.

Relay lever with clip - arrow 1 - (see illustration N34-11141):

• The clip - arrow 1 - secures the relay lever.

• Make sure the clips locks securely.

• The cable retainer must be behind the latch - arrow 2 -.

Removing the selector cable retainer from the plastic relay lever.





• The relay lever is removed

- Insert a flat blade screwdriver - A - between the bushing - B - and the relay lever.

Installing the cable retainer





• The relay lever is removed

• The cable retainer may only be installed at the bushing - arrow -.

• The cable retainer must move freely on the relay lever.

• It must be behind the latch - arrow 2 -. Refer to => [ From 03.07 - relay lever is plastic ].