Dual Mass Flywheel

Dual Mass Flywheel

Special tools, testers and auxiliary items required

• Flywheel Retainer (3067)

Removing

- Remove the transmission.


To prevent damage to the dual mass flywheel when removing, the bolts - B - must not be loosened using an air-powered or impact wrench. Only loosening the bolts by hand is permitted.

- Rotate the dual mass flywheel - A - so that the bolts - B - are centered with the holes - arrows -.






- When removing the bolts - B -, make sure the bolt head does not come into contact with the dual mass flywheel - arrows - or the flywheel could be damaged when turning the bolt.

- Install the flywheel retainer (3067) to the hole in the cylinder block - B -.






- Remove the dual mass flywheel.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Tightening specification, see => [ (Item 6) Bolt ] Service and Repair.

- Install using new bolts.

- Install the flywheel retainer (3067) to the hole in the cylinder block - A -.