Rear Bumper Cover through 12.10

Rear Bumper Cover

• Slight changes may have to be made to removal and installation procedures of rear bumper cover, depending upon equipment installed in vehicle.

Removing






- Remove tail lamp assemblies in side panel.

- Remove bolts - 2 - on left and right sides.

- Remove bolts - 3 - from below.

- Remove screws - 4 - in area of left and right wheel housing liner.

- Pry out expanding rivet - 5 - in area of left and right wheel housing liners using a screwdriver.

A second mechanic is required for the rest of the removal procedure.

- Pull rear bumper cover - 1 - parallel out of guide profiles in side panel.

- Disconnect harness connectors of installed electrical components.

Installation

Install in reverse order of removal.

- Pay attention to the parallel alignment and gap dimensions.