Sealing Flange and Drive Plate Overview

Sealing Flange and Drive Plate Overview

• Secure the engine to engine and transmission holder (VAS 6095) when working on it.






1 Bolt

• Removing and installing, refer to one of the following:

Engine code BLV, refer to => [ Vibration Damper ] Service and Repair.

Engine code CNNA, refer to => [ Vibration Damper ] Service and Repair.

2 Vibration Damper

• Removing and installing, refer to one of the following:

Engine code BLV, refer to => [ Vibration Damper ] Service and Repair.

Engine code CNNA, refer to => [ Vibration Damper ] Service and Repair.

3 Bolt

• 10 Nm

4 Sealing Flange

• Removing and installing, refer to one of the following:

Engine code BLV, refer to => [ Crankshaft Sealing Flange, Vibration Damper Side ] Crankshaft Sealing Flange, Vibration Damper Side

Engine code CNNA, refer to => [ Crankshaft Sealing Flange, Vibration Damper Side ] Crankshaft Sealing Flange, Vibration Damper Side

• Coat the sealing surfaces with silicone adhesive sealant (D 176 501 A1).

5 Cylinder Block

• Crankshaft overview. Refer to => [ Crankshaft Overview ] Service and Repair.

• Piston and connecting rod overview. Refer to => [ Piston and Connecting Rod Overview ] Piston and Connecting Rod Overview.

6 Sealing Flange

• Removing and installing, refer to => [ Sealing Flange, Transmission Side ] Service and Repair.

7 Seal

• Remove using the pulling hook (T20143/2).

• Polytetrafluoroethylene (PTFE) version of the seal.

• Do not lubricate or grease the sealing lip on the seal.

• Wipe off any oil on the crankshaft journal with a clean cloth before installing.

• Installing, refer to => [ Crankshaft Seal, Transmission Side ] Crankshaft Seal, Transmission Side.

8 Shim

9 Bolt

• 60 Nm + an additional 90° (1/4) turn.

• Always replace.

• To loosen or tighten, use the counter hold tool (T10044) (with 5 mm spacers), or the counter-holder tool (T10069).

10 Washer

11 Drive Plate

• Removing and installing, refer to => [ Drive Plate ] Drive Plate.

12 Bolt

• 23 Nm