Selector Lever Handle

Selector Lever Handle

Short Description

There are different handles depending on the model.

The handle is removed together with the shift cover.

Removing

- Move the selector lever into the "D" position.

Handle with the Button on the Side






- Pull the button out of the handle just far enough until there is a small gap between the handle and the button. The button locks when released.

- Prevent the button from being pressed in with a cable tie or wire.

Handle with the Button in the Front






It is not necessary to pull out the button manually. The button locks in the installed position - arrow -. when the handle is removed.

Continuation for all Handles






- Remove the cover.

- Disconnect the connector from the selector cover.

- Push the sleeve upward and unlock the handle.

Only Handles with Clamps






- Cut the clamp under the boot - arrow - with side cutters.

Continuation for all Handles

- Remove the handle from the selector lever without pushing the button.

• Do not push the button once the handle has been removed otherwise it will not be possible to install the handle again.

Installing

- Install in reverse order of removal. Note the following:

• The selector lever is in the "D" position.

Handle with the Button on the Side






• The button inside the handle is pulled out and is protected from getting pushed in again.

Handle with the Button in the Front






• The button is in the installed position - arrow -.

If the button was pushed in by mistake, the installed position can be set again.

- Move the button to the installed position. Refer to => [ Handle Button, Moving to Installed Position ] Handle Button, Moving to Installed Position.

• A new handle is delivered with an assembly aid. Pull out the assembly aid just prior to installation.






Continuation for all Handles

- Install the handle all the way onto the selector lever and lock it.

- Push the sleeve down to lock it.

Only Handles with Clamps

- Install the handle with a new clamp.

- Tighten the clamp using the hose clamp pliers (V.A.G 1275).

- Press the button after installing it.

• If the button stays in the handle after being pressed, this means it was installed incorrectly. If this happens, remove the handle again and move the button to the installed position again. Refer to => [ Handle Button, Moving to Installed Position ] Handle Button, Moving to Installed Position. Then install the handle again.

Further installation is performed in the reverse sequence.