Rear Side Window

Rear Side Window

Removing

- Loosen interior trim in upper area

- Remove B- and C-pillar trim





- Thrust awl (V.A.G 1474/2) - 1 - through adhesive bead.

- Push cutting cord through adhesive sealing material into vehicle interior - 3 - using awl (V.A.G 1474/2 ) - 2 -.

- Secure end of cutting cord on inside against pulling out using pull handle (V.A.G 1351/1) - 1 -.





- Loosen sealing lip all around from window flange and spray with cleaning solution D 009 401 01 (as a substitute for lubricant).

- Place cutting cord - 2 - around side window.

- Using a small tube - 3 -, guide cutting cord - 2 - between lip and window flange and also guide second cord end inside.

- Secure second cord end to spooling tool (V.A.G 1654 A) and cut window free by positioning spooling tool.





- While cutting free, press cutting cord against window using wedge (V.A.G 1474/5) to have clearance to window flange.

Installing

Window, Preparing for Glazing => [ Window, Undamaged, Preparing for Glazing ] Window, Undamaged, Preparing for Glazing

Window, New, Preparing for Glazing => [ Window without Pre-Coating, New, Preparing for Glazing ] Window without Pre-Coating, New, Preparing for Glazing

Window Flange, Preparing for Glazing => [ Window Flange, Preparing for Glazing ] Window Flange, Preparing for Glazing

Installation Information => [ Installation Information ] Installation Information

Minimum Curing Time => [ Minimum Curing Time ] Minimum Curing Time