Side Trim, 2-Door

Pillar and Side Trim

Side Trim, 2-door

• Removal and installation is described for the right side of the vehicle. Removing and installing on the left side is identical.

Removal

- Remove upper B-pillar trim. Belt anchor rail does not need to be removed from front seat belt. Refer to => [ Upper B-pillar Trim ]. Upper B-Pillar Trim

- Remove seat bench. Refer to => [ Bench Seat ] Rear Seats.

- Remove cover cap - 1 - from mounts and remove screw - 2 - (2 Nm).

- Remove sill panel trim from mounts in side trim in lower area.

- Remove side trim from mounts in body.

- In vehicles with radio system, disconnect wiring harness from speaker - 3 -.

- In vehicles with interior monitoring system, disconnect wiring harness from sensor.





Installation

- To install, perform the steps used for removal in reverse order.

• Before installing, check securing clips for damage and replace if necessary.