Right Drive Flange Shaft Oil Seal

Right Drive Flange Shaft Oil Seal

Seal and Sleeve are Designed as Two Parts

Special tools, testers and auxiliary items required

• Assembly tool (3253/2)

• Torque wrench 5 to 50 Nm (V.A.G 1331)

• Drip tray for shop crane (VAS 6208)

• Thrust piece (T10160)

Seal and Sleeve are Designed as One Part

Special tools, testers and auxiliary items required

• Thrust piece (T10148)

• Spindle from seal installer set - rear diff (3066)

• Slide hammer-complete set (VW 771)

• Pulling hook (VW 771/37)

• Torque wrench 5 to 50 Nm (V.A.G 1331)

Removing

- Remove center and right sections of sound insulation below engine/transmission.

- Turn steering as far as possible toward right.

- Remove protective cap for drive axle from engine, if present.

- Remove drive axle - 1 - from flanged shaft.





- Tie up drive axle as high as possible. Do not damage paint on drive axle when doing so.

- Place drip tray under engine.

- Remove bolt for flange shaft. To do this, screw two bolts into flange and counter-hold flange shaft centrally using a pry bar.

- Pull out flanged shaft with compression spring.

Seal and Sleeve are Designed as Two Parts

- Pry out seal using screwdriver - A -. Support screwdriver with assembly tool (3253/2).





• Do not damage sleeve, otherwise there is the risk of leaks.

• Replace sleeve if damaged => [ Pry out sleeve using
screwdriver ] Transmission and Clutch Housing

Seal and Sleeve are Designed as One Part

- Pull out seal and sleeve together.

A ridge is located on inner diameter of sleeve.

- Position puller hooks pulling hook (VW 771/37 ) directly behind ridge in sleeve.





- While pulling out, press pulling hook (VW 771/37 ) forcefully into sleeve.

Installing

Seal and Sleeve are Designed as Two parts

- Drive in new seal up to stop. Do not distort oil seal.





- Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).

Seal and Sleeve are Designed as One Part

- Clean gasket seat in transmission.

- Pull in seal and sleeve together.





- Screw spindle - A - of Seal installer set - rear diff (3066) into threaded piece of differential.

- Pull seal with sleeve in up to stop using thrust pad (T10148) by turning nut - B -.

- Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).

Continuation for All

- Secure flange shaft with countersunk bolt and tighten countersunk bolt to 25 Nm.

- Secure drive axle- 1 - to flange shaft.





- If equipped, install protective shield for drive axle to engine and tighten bolts to 35 Nm.

- Checking and filling up gear oil => [ Gear Oil, Checking and Filling ] Service and Repair.

- Install center and right sections of sound insulation below engine/transmission.

Tightening Specifications