Clutch Switch: Service and Repair

Clutch Pedal Switch

In order to assure secure fitting, clutch pedal switch (F36) must not be installed more than once.

Removing

- Slide driver's seat toward rear as far as possible and bring steering wheel to highest position.

- Remove cover in driver's side footwell.

- Disconnect connector from clutch pedal switch ( F36).

- Rotate clutch pedal switch (F36) at housing 45 degrees toward left and remove from mount.





Installing and Adjusting

Installation is in reverse order of removal. Note the following:

During installation of clutch pedal switch, clutch pedal always remains in rest position (not operated).

• Check clutch pedal switch first.





• Stop - A - must be located in front of section - B -.

• Stop - C - is then located directly below take-up hook.

If this is not the case, plunger must not be pulled out.

Otherwise, the clutch pedal switch will be destroyed.

Positions of stops - A - and - C - must be corrected:

- Press in plunger until it stops - arrow 1 -.





- At the same time, rotate upper part of clutch pedal switch in direction of - arrow 2 - until stop.

- Before installing clutch pedal switch (F36), pull out plunger completely.

- Insert clutch pedal switch (F36) into assembly hole.

- To engage, turn clutch pedal switch (F36) at housing 45 degrees toward right.

- Connect connector on clutch pedal switch (F36 ).

- Install cover in driver's side footwell.