Oil Cooler

Oil Cooler

Special tools, testers and auxiliary items required

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Drip Tray for VAS 6100 (VAS 6208) or (V.A.G 1306)

Removing


Risk of scalding due to hot steam and hot coolant:

• The coolant system is under pressure when the engine is warm.

• Wear protective goggles and protective clothing to prevent damage to eyes and scalding.

• Reduce pressure by covering the coolant expansion tank cap with a cloth and carefully opening.

- Drain the coolant. Refer to => [ Draining and Filling ] Service and Repair.

- Remove the accessory bracket. Refer to => [ Accessory Bracket ] Service and Repair.

- Remove the bolts - 4 and 5 - and remove the oil cooler - 3 - together with the seal - 2 -.






Installing

• Tightening specifications, refer to => [ Oil Filter, Oil Cooler and Oil Pressure Switch Overview ] Service and Repair.

Install in reverse order of removal. When doing this note the following:

• Always replace gaskets and seals.

• Install only approved clamps for securing hose connections.

- Install the oil cooler - 3 - with a new seal - 2 -.