Sunroof Glass Panel, Adjusting Height

Sunroof Glass Panel, Adjusting Height

• The glass panel height adjustment is to be performed after the glass panel has been closed out of sliding position.

Zero position of glass panel for sunroof OK (checking, refer to => [ Sunroof Glass Panel Drive Motor, Adjusting Neutral Position ] Sunroof Glass Panel Drive Motor, Adjusting Neutral Position).

- Remove bellows, refer to => [ Bellows ] Bellows.





- Loosen left and right mounting bolts - 1 - for glass panel for sunroof - 2 - (do not remove).

- Drive sunroof glass panel into position "open".

- Drive sunroof glass panel into position "closed".

- Perform height adjustment for glass panel for sunroof at front and rear on both sides as follows:

Panel adjustment at front:





- a - = 0 to 1 mm lower than roof

- Arrow - points toward the front of the vehicle.

- Tighten front bolts on left and right (5 Nm).

Panel adjustment at rear:





- b - = 0 to 1 mm higher than roof

- Arrow - points toward front of vehicle.

- First tighten center, then rear bolts on left and right to 5 Nm.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

• Glass panel must not be higher than roof at any point at front or lower than roof at any point at rear.

- Install bellows, refer to => [ Bellows ] Bellows.