Hose Connections With Connection Couplings, Assembly

Hose Connections with Connector Couplings, Assembling


Connector coupling seals can be damaged if the clamp is in the locked position when installing. This would result in a leak. Follow the assembly instructions.

Removing

- Release the connector coupling by pulling the clip - arrow -. Separate the hose/pipe without assistance from tools.





Installing

- When replacing the seal, place it in the groove in the charge air hose. Ensure the seal sits completely in the groove all the way around and is not twisted.

- Lubricate the sealing surfaces and seal.

- Bring the clip into the released position - 1 -.





- Slide the charge air hose into the pipe until seated.

- Bring the clip into the locked position - 2 - and then pull the charge air hose back again.

- Check for correct seating and proper locking of the connector by pulling on the hose.