Spray Jet Telescoping Cylinder

Spray Jet Telescoping Cylinder






Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove spray nozzles with cover cap - 1 - up to stop out of bumper cover.

- Unclip cover cap - 1 - from bearings - arrows - on spray nozzle holder.

- Remove front bumper cover.

- Pull off securing clip - 4 - from the hose connection.






- Disconnect the hose connection from lift cylinder - 2 -.

- Remove screw - 1 -.

- Unclip lift cylinder - 2 - from bracket - 3 -.

Installation

Install in reverse order of removal, noting the following:

- The hose to lift cylinder must be clipped into hose bracket.

- Tighten all threaded connections to specified torques. Refer to => [ Windshield Wiper and Washer System, Tightening Specifications ] [1][2]Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Headlamp Washer System, Bleeding.