Leak Detection Pump (V144)

Leak Detection Pump (V144)

Removing

- Disconnect the vacuum line - 1 -, ventilation line - 2 - and ventilation line - 3 -.






- Remove the nuts - arrows -.

- Remove the leak detection pump with bracket and disconnect the electrical connector.

Installing

Installation is performed in the reverse order of removal, noting the following:

• Before installing the pump with bracket, connect the electrical connector.

• The vent line - 2 - must engage audibly.

Tightening specifications, refer to => [ EVAP System Components ] EVAP System Component Overviews.