Flywheel: Service and Repair

Flywheel

Special tools, testers and auxiliary items required

• Flywheel Retainer (3067)

Removing

• To prevent damage to the dual-mass flywheel when removing it, the bolts - B - must not be removed using an air-powered or impact wrench. Only removing the bolts - B - by hand is permitted.

- Rotate the dual-mass flywheel - A - so that the bolts - B - are centered with the holes - arrows -.






- When removing the bolts - B -, make sure that the bolt head is not jammed on the flywheel.

- Install the flywheel retainer (3067) in the hole on the cylinder block.






- Mark the flywheel to the engine.

- Remove the flywheel.

Installing

Install in reverse order of removal. Note the following:

- Replace the flywheel bolts.

Tightening Specification






1 90° corresponds to a 1/4 turn