Fuel Rail

Fuel Rail

Removing

- Remove the intake manifold. Refer to => [ Intake Manifold ] Intake Manifold.

- Disconnect the hose from the Evaporative Emission (EVAP) canister.

- To do so, remove the hose clamp bolt - 1 -.





- Loosen the two fuel rail bolts - arrows -.

- Remove the hose connection - 1 - from the intake manifold and loosen both bolts - arrows -.





- Loosen the union nuts of both fuel pipes - 2 and 3 -. Counter hold the pressure relief valve when doing this.

- Carefully pry off the linkage from the intake flap motor (V157) - 4 -.

- Remove the intake flap motor bolts - 5 -.

- Remove the fuel rail from the intake manifold.





Installing

- Installation is performed in reverse order.

Tightening specifications (vehicles through 05.06). Refer to => [ Fuel Rail, Injectors and Pipes Overview, through 05.06 ] .

Tightening specification (vehicles from 06.06). Refer to => [ Fuel Rail, Injectors and Pipes Overview, from 06.06 ] Fuel Rail, Injectors and Pipes Overview, from 06.06.