Sealing Flange, Drive Plate/Flywheel Side

Sealing Flange, Drive Plate/Flywheel Side

Removing

- Remove the transmission.

- Remove the drive plate or flywheel, refer to one of the following:

=> [ Drive Plate ] Service and Repair.

=> [ Flywheel ] Service and Repair.

- Remove the oil pan. Refer to => [ Oil Pan ] Oil Pan.

- Remove the sealing flange bolts - arrows - and sealing flange.





Installing

• Do not additionally oil or grease the sealing lip of the oil seal!

- Clean the sealing surfaces. They must be free of oil and grease.

- Before installing, remove any oil remaining on the end of the crankshaft with a clean cloth.

- To install, use the support sleeve provided. The support sleeve may only be removed after the sealing flange has been slid onto the crankshaft. Sealing flange sits on the alignment pins.

- Tighten the bolts - arrows - to 15 Nm.





- Install the oil pan. Refer to => [ Oil Pan ] Oil Pan.

The rest of the installation is basically a reverse of the removal sequence.