Diagnostic Tester, Connecting

Diagnostic Tester, Connecting

Recommended Special Tools And Equipment E.g.:







- VAS5052 Vehicle Diagnostic and Service Information System with
- VAS 5052/3 diagnostic cable

Requirements







- The respective fuses of Diesel-Direct fuel injection system must be OK.
- Battery voltage must be at least 11.5 volts.
- All electrical consumers such as, lights and rear window defroster must be switched off
- For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
- Parking brake must be engaged.
- If vehicle is equipped with an A/C system, it must be switched off.
- Ground (GND) connections between engine and chassis must be OK.
- Ignition switched off.

Work procedure
Connect diagnostic tester (VAS 5052) using (VAS 5052/3) diagnostic cable as follows:







- Connect diagnostic cable connector to Data Link Connector (DLC) (arrow).
- Depending on desired diagnostic mode, it is necessary to:switch on ignition or start engine and let it run at idle, selectable diagnostic modes under address word 33. Selectable Diagnostic Modes Under Address Word 33 - OBD

NOTE:
- Respective operation of the diagnostic tester:
- If no display appears on diagnostic tester, check voltage supply at Data Link Connector (DLC).