Diagnostic Trouble Code Memory, Erasing

Requirement
- DTC memory has been checked. Diagnostic Trouble Code Memory, Checking

After DTC memory has been checked;


Indicated on display


Rapid data transfer HELP
Select function XX

- Press buttons -0- and -5- to select "Erase DTC memory" function 05.


Indicated on display


Rapid data transfer Q
05 - Erase DTC memory

- Confirm entry with -Q- button.


Display reads


Attention!
DTC memory was not checked.


NOTE:
- If the ignition was switched off between checking the DTC memory and erasing the DTC memory the DTC memory will not be erased.
- Always adhere strictly to the sequence of operations, i.e. first check DTC memory.


Indicated on display


Rapid data transfer ->
DTC memory is erased!

(The DTC memory will be erased approx. 5 secs. after the display appears.)


NOTE: Wait about 1 minute before again checking the DTC memory.


Indicated on display


System cannot be checked!


Print out with printer switched on


1 DTC recognized!
00811 3333
System cannot be checked

The TCM -J217- was not given sufficient time to recognize malfunctions.

- Wait about 1 minute before again checking DTC memory.
- After checking and erasing DTC memory, test drive vehicle and check DTC memory again.

The following display should appear:
"No DTC recognized!"