P0405

EGR LIFT SENSOR 1












1. CHECK THE VOLTAGE BETWEEN SENSOR TERMINALS.
1. Set the starter switch to "LOCK" position and connect the signal check harness.
2. Disconnect the connectors of EGR valve1.
3. Set the starter switch to "ON" position.
4. Measure the voltage between LSG1 and LSV1 terminals of connector (vehicle harness side) of EGR sensor.

Standard: 4.5 - 5.5 V
(After measurement, turn the starter switch to "LOCK" position.)












2. CHECK THE VOLTAGE BETWEEN TERMINALS.
1. Measure the voltage between AGD3 (D35) and AVC3 (D22) terminals of signal check harness.

Standard: 4.5 - 5.5 V












3. CHECK THE VOLTAGE BETWEEN TERMINALS.
1. Set the starter switch to "LOCK" position and connect the connector of EGR valve1.
2. Set the starter switch to "ON" position.
3. Measure the voltage between EGS1 (D26) and AGD3 (D35) terminals of signal check harness.

Standard: 1.3 - 4.0 V












4. CHECK THE VOLTAGE BETWEEN SENSOR TERMINALS
1. EGR lift sensor connector remains connected.
2. Measure the voltage between LSS1 and LSG1 terminals of EGR sensor connector (vehicle side).

Standard: 1.3 - 4.0 V