P0335

ENGINE SPEED MAIN SENSOR







1. CHECK THE RESISTANCE BETWEEN TERMINALS.







1. Set the starter switch to "LOCK" and connect the signal check harness.
2. Disconnect the signal check harness connector on the ECU side.
3. Measure the resistance between NE1+ (B6) and NE1- (B7) terminals of ECU connector (vehicle harness side).

Standard: 108.5 - 142.5 ohms at 20 °C {68 °F}







2. RECHECK THE DTC.
1. Connect the signal check harness connector on the ECU side.
2. Erase the DTC.
3. Check the DTC.










3. CHECK THE ENGINE SPEED MAIN SENSOR.
1. Disconnect the connectors of engine speed main sensor.
2. Measure the resistance between terminals of engine speed main sensor.

Standard: 108.5 - 142.5 ohms at 20 °C {68 °F}