Installation (from 07/2011)

U340E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER (for Hatchback): INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY

(a) Install the shift lever assembly with the 4 bolts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

NOTICE:
Make sure that the wire harness is not caught under the shift lever.

(b) Engage the 3 clamps and install the wire harness to the shift lever assembly.

(c) Connect the 2 connectors to the shift lever assembly.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Rotate the nut of the transmission control cable assembly counterclockwise 180° and push in the lock while holding the nut.





Text in Illustration





(b) Install the outer part of the transmission control cable assembly to the shift lever retainer.





Text in Illustration





NOTICE:
After installation, check that the cable outer lock extends past the line A-A, as shown in the diagram.

(c) Confirm that the shift lever is in N and connect the end of the transmission control cable assembly to the shift lever assembly.





NOTICE:
* Push the cable end to the base of the pin to be sure that it is installed securely.
* Install the cable end adjustment mechanism so that the lock faces the driver seat.

3. ADJUST SHIFT LEVER POSITION Adjustments

4. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

5. INSTALL REAR CONSOLE BOX ASSEMBLY

Installation (from 07/2011)

6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

(a) Turn the shift lever knob clockwise and install the shift lever knob sub-assembly to the shift lever assembly.





Text in Illustration





NOTICE:
When tightening the shift lever knob sub-assembly, do not hold the knob cover. Instead, hold the knob itself when tightening.