Removal

AUDIO / VIDEO: RADIO ANTENNA CORD: REMOVAL

1. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Removal

2. REMOVE RADIO WIRE SUB-ASSEMBLY

(a) Disconnect the connector.

(b) Using a screwdriver, disengage the claw and remove the radio wire connector.





Text in Illustration





HINT
Tape the screwdriver tip before use.

(c) Disconnect the connector and remove the bolt.





(d) Disengage the 6 clamps and remove the radio wire sub-assembly.

3. REMOVE ROOF HEADLINING ASSEMBLY

Removal

4. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof)

(a) Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.

HINT
Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

(b) Pull out the antenna cord from the slit and then remove the antenna cord from the roof headlining.





Text in Illustration





5. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof)

(a) Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.

HINT
Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

(b) Pull out the antenna cord from the slit.

(c) Disengage the 3 clamps and remove the antenna cord from the roof headlining.





Text in Illustration