Installation

U760E AUTOMATIC TRANSAXLE: VALVE BODY ASSEMBLY: INSTALLATION

1. INSTALL MANUAL VALVE

(a) Coat the manual valve with ATF and install it to the valve body.





2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

(a) Coat the O-ring of the transmission wire with ATF.

(b) Confirm that the manual valve lever is positioned as shown in the illustration and install the valve body assembly to the transaxle case with the 11 bolts.





Bolt A, B, C - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

Bolt D - Torque : 9.6 Nm (98 kgf-cm, 85 in-lbf)

Bolt length:

Bolt A
25 mm (0.984 in.)

Bolt B
30 mm (1.18 in.)

Bolt C, D
35 mm (1.38 in.)

NOTICE:
* When installing the transmission valve body assembly, be careful not to allow the speed sensor and transaxle case to interfere with each other.
* Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
* First, temporarily tighten the bolts marked by (*1) in the illustration because they are positioning bolts.

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

(a) Coat a new O-ring with ATF and install it to the oil strainer.





NOTICE:
Ensure that the O-ring is not twisted or pinched.

(b) Install the oil strainer to the valve body with the 2 new bolts.





Torque : 9.6 Nm (98 kgf-cm, 85 in-lbf)

4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

(a) Install the 2 magnets to the oil pan.





(b) Install a new gasket to the oil pan.

(c) Install the oil pan to the automatic transaxle with the 17 bolts.





Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

NOTICE:
Completely remove any oil or grease from the contact surface of the transaxle case and oil pan sub-assembly with the gasket before installation.

(d) Apply adhesive to the 2 new bolts.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

(e) Install the oil pan to the automatic transaxle with the 2 bolts.





Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

NOTICE:
In order to ensure proper sealing of the transmission oil pan bolts, apply sealant to the bolts and install them within 10 minutes of sealant application.

5. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT
Installation