Removal

U760E AUTOMATIC TRANSAXLE: SHIFT LEVER: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal

3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) Removal

5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) Removal

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (without Smart Key System) Removal

7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (with Smart Key System) Removal

8. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

(a) Turn the shift lever knob counterclockwise and remove it.





9. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

10. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

11. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Removal

12. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY Removal

13. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made) Removal

14. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made) Removal

15. REMOVE CONSOLE BOX POCKET Removal

16. REMOVE CONSOLE BOX CARPET Removal

17. REMOVE CONSOLE BOX ASSEMBLY (for TMC Made) Removal

18. REMOVE CONSOLE BOX ASSEMBLY (for TMMK Made) Removal

19. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made) Removal

20. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made) Removal

21. REMOVE FLOOR CARPET BRACKET LH Removal

22. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Disconnect the end of the transmission control cable from the shift lock control unit.





(b) Disconnect the transmission control cable assembly from the transmission floor shift assembly while pushing the 2 claws of the floor shift cable.

23. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

(a) Disconnect the shift lock control ECU connector and transmission control switch connector.





(b) Disconnect the wire harness clamp and remove the screw.

(c) with rear register duct:

(1) Remove the clip.

(d) Remove the 4 bolts and shift control unit assembly.