Installation

SUSPENSION: REAR STRUT ROD: INSTALLATION

1. TEMPORARILY TIGHTEN REAR STRUT ROD

(a) Install the rear strut rod (rear side), bolt and nut, and temporarily tighten the bolt.





NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.

(b) Support the rear axle carrier.





(c) Connect the rear strut rod (inner side) with the bolt and nut.





NOTICE:
When temporarily tightening the bolt, keep the nut from rotating.

2. STABILIZE SUSPENSION

(a) Jack up the rear axle carrier, placing a wooden block to avoid damage. Apply load to the suspension so that the installed bolt of the rear suspension No. 1 arm (inner side of vehicle) is horizontally aligned with the center of the rear axle hub.





3. FULLY TIGHTEN REAR STRUT ROD

(a) Fully tighten the bolt.





Torque : 113 Nm (1,152 kgf-cm, 83 ft-lbf)

(b) Fully tighten the bolt.





Torque : 113 Nm (1,152 kgf-cm, 83 ft-lbf)

4. CONNECT PARKING BRAKE NO. 3 CABLE ASSEMBLY

(a) Install the parking brake No. 3 cable assembly with the bolt.





Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

5. INSTALL NO. 2 FLOOR UNDER COVER (w/ Cover) Installation

6. INSTALL NO. 1 FLOOR UNDER COVER (w/ Cover) Installation

7. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)