Installation

SUSPENSION: FRONT LOWER BALL JOINT: INSTALLATION

1. INSTALL FRONT LOWER BALL JOINT

(a) Install the front lower ball joint to the steering knuckle with the nut.

Torque : 123 Nm (1,250 kgf-cm, 91 ft-lbf)

NOTICE:
Prevent oil from adhering to the screw and tapered parts.

(b) Install a new cotter pin.

NOTICE:
If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

2. INSTALL FRONT AXLE HUB BEARING Installation

3. INSTALL FRONT DISC BRAKE DUST COVER Installation

4. INSTALL FRONT AXLE HUB Installation

5. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation

6. INSTALL FRONT WHEEL NO. 1 BEARING DUST DEFLECTOR Installation

7. INSTALL FRONT AXLE ASSEMBLY Installation

8. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM Installation

9. CONNECT TIE ROD END SUB-ASSEMBLY Installation

10. INSTALL FRONT DISC Reassembly

11. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

12. INSTALL FRONT SPEED SENSOR Installation

13. INSTALL FRONT AXLE HUB NUT Installation

14. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Installation

15. REMOVE FRONT DISC Disassembly

16. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

17. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

18. INSTALL FRONT DISC Reassembly

19. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

20. INSTALL FRONT AXLE HUB NUT Installation

21. CHECK ABS SPEED SENSOR SIGNAL

HINT
* VSC (for BOSCH): Test Mode Procedure
* VSC (for ADVICS): Test Mode Procedure

22. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

23. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Front Wheel Alignment