Installation

SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE

(a) Engage the 6 claws and install the spiral cable to the steering angle sensor.





2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Check that the front wheels are facing straight ahead.

(b) Set the turn signal switch to the neutral position.

NOTICE:
If it is not in the neutral position, the pin of the turn signal switch may be snapped.

(c) Engage the 3 claws and install the spiral cable with steering angle sensor.





NOTICE:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

(d) Connect the connectors to the spiral cable with steering angle sensor.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

3. INSTALL STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Rotate the spiral cable counterclockwise slowly by hand until it feels firm.





NOTICE:
Do not turn the spiral cable by the airbag wire harness.

(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.





NOTICE:
Do not turn the spiral cable by the airbag wire harness.

HINT
The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

5. INSTALL STEERING WHEEL ASSEMBLY Installation

6. INSPECT STEERING WHEEL CENTER POINT

7. INSTALL STEERING PAD Installation

8. INSTALL NO. 3 LOWER STEERING WHEEL COVER Installation

9. INSTALL NO. 2 LOWER STEERING WHEEL COVER Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT STEERING PAD Installation

12. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System for TMC made, Diagnosis System except TMC made).