Removal

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT PASSENGER AIRBAG ASSEMBLY: REMOVAL

1. TABLE OF BOLT, SCREW AND NUT

HINT
Service Precautions

2. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Airbag System (for TMC Made) for TMC made, Airbag System (except TMC Made) except TMC made).

3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

5. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal

6. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

7. REMOVE STEERING PAD Removal

8. REMOVE STEERING WHEEL ASSEMBLY Removal

9. REMOVE FRONT DOOR SCUFF PLATE LH Removal

10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) Removal

12. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) Removal

13. REMOVE STEERING COLUMN COVER (for TMC Made) Removal

14. REMOVE STEERING COLUMN COVER (for TMMK Made) Removal

15. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Removal

16. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Removal

17. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System) Removal

18. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System) Removal

19. REMOVE INSTRUMENT CLUSTER FINISH PANEL Removal

20. REMOVE COMBINATION METER ASSEMBLY (for TMC Made) Removal

21. REMOVE COMBINATION METER ASSEMBLY (for TMMK Made) Removal

22. REMOVE FRONT DOOR SCUFF PLATE RH Removal

23. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH Removal

24. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Removal

25. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) Removal

26. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) Removal

27. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal

28. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal

29. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

30. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

31. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle) Removal

32. REMOVE UPPER CONSOLE PANEL (for Manual Transaxle) Removal

33. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle) Removal

34. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle) Removal

35. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made) Removal

36. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made) Removal

37. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY Removal

38. REMOVE RADIO RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (w/o Navigation System) Removal

39. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY (w/ Navigation System) Removal

40. REMOVE CONSOLE BOX POCKET Removal

41. REMOVE CONSOLE BOX CARPET Removal

42. REMOVE CONSOLE BOX ASSEMBLY (for TMC Made) Removal

43. REMOVE CONSOLE BOX ASSEMBLY (for TMMK Made) Removal

44. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made) Removal

45. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made) Removal

46. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made) Removal

47. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made) Removal

48. REMOVE FRONT PILLAR GARNISH LH Removal

49. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY Removal

50. REMOVE INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY Removal

51. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side) Removal

52. REMOVE FRONT PILLAR GARNISH RH Removal

53. REMOVE INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY Removal

54. REMOVE INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY Removal

55. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side) Removal

56. REMOVE NO. 1 DEFROSTER NOZZLE GARNISH Removal

57. DISCONNECT INSTRUMENT PANEL WIRE ASSEMBLY

(a) Disconnect the connector.





58. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made) Removal

59. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made) Removal

60. REMOVE NO. 3 INSTRUMENT PANEL STAY Removal

61. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

(a) Remove the 2 screws.





(b) Disengage the 10 hooks and remove the front passenger airbag assembly from the instrument panel.





62. REMOVE INSTRUMENT PANEL WIRE ASSEMBLY

(a) Disconnect the 2 connectors.





(b) Remove the clamp and the instrument panel wire assembly from the front passenger airbag assembly.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.