Installation
SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION
HINT
* Use the same procedures for the RH side and the LH side.
* The procedures listed below are for the LH side.
1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Install a 4 new clips and 4 new spacers to the curtain shield airbag assembly as shown in the illustration.
NOTICE:
* Do not push in the pin.
* Make sure that the clips are installed in the correct direction.
* Make sure that the spacers are installed properly, in the correct direction, and that they are not damaged.
(b) Install the curtain shield airbag assembly with the 5 new bolts.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
NOTICE:
Do not twist the curtain shield airbag assembly when installing it.
(c) Install the 4 clips with the curtain shield airbag assembly to the body panel as shown in the illustration.
NOTICE:
Make sure that the pins of the clips are pushed in firmly.
(d) Mark the clips.
HINT
Mark the clips to make sure that they are not reused.
(e) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof) Installation
3. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof) Installation
4. INSTALL SUNSHADE TRIM HOLDER (w/ Rear Sunshade) Installation
5. INSTALL SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof) Installation
6. INSTALL SPOT LIGHT ASSEMBLY (w/ Sliding Roof) Installation
7. INSTALL NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof) Installation
8. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY Installation
9. INSTALL REAR ASSIST GRIP SUB-ASSEMBLY Installation
10. INSTALL VISOR HOLDER Installation
11. INSTALL VISOR ASSEMBLY LH Installation
12. INSTALL VISOR ASSEMBLY RH Installation
13. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation
14. INSTALL FRONT PILLAR GARNISH LH Installation
15. INSTALL FRONT PILLAR GARNISH RH Installation
16. INSTALL ROOF SIDE INNER GARNISH LH Installation
17. INSTALL ROOF SIDE INNER GARNISH RH Installation
18. INSTALL UPPER CENTER PILLAR GARNISH LH Installation
19. INSTALL LOWER CENTER PILLAR GARNISH LH Installation
20. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation
21. INSTALL LAP BELT OUTER ANCHOR COVER (for LH Side) Installation
22. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation
23. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation
24. INSTALL FRONT DOOR SCUFF PLATE LH Installation
25. INSTALL UPPER CENTER PILLAR GARNISH RH Installation
26. INSTALL LOWER CENTER PILLAR GARNISH RH Installation
27. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Installation
28. INSTALL LAP BELT OUTER ANCHOR COVER (for RH Side) Installation
29. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation
30. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation
31. INSTALL FRONT DOOR SCUFF PLATE RH Installation
32. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH Reassembly
33. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH Reassembly
34. INSTALL DOOR ASSIST GRIP COVER LH Reassembly
35. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH Reassembly
36. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH (for Reclining Seat Type) Reassembly
37. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH (for Reclining Seat Type)
HINT
Use the same procedures for the RH side and the LH side.
38. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation
39. INSTALL REAR DOOR SCUFF PLATE LH Installation
40. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation
41. INSTALL REAR DOOR SCUFF PLATE RH Installation
42. INSTALL CENTER SEAT BACK ASSEMBLY (for Reclining Seat Type) Installation
43. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Reclining Seat Type) Installation
44. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Reclining Seat Type) Installation
45. INSTALL REAR SEAT BACK COVER (for Reclining Seat Type)
46. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation
47. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH (for Fold Down Seat Type)
48. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY LH (for Fold Down Seat Type) Installation
49. INSTALL SEPARATE TYPE REAR SEAT BACK ASSEMBLY RH (for Fold Down Seat Type) Installation
50. INSTALL REAR SEAT BACK ASSEMBLY (for Fixed Seat Type) Installation
51. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
52. INSTALL REAR SEAT HEADREST ASSEMBLY
53. INSTALL REAR SEAT CUSHION ASSEMBLY
54. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) Installation
55. INSTALL SEAT TRACK COVER RH (for Power Seat) Installation
56. INSTALL SEAT TRACK COVER LH (for Power Seat) Installation
57. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Power Seat)
58. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)
HINT
Use the same procedures for the RH side and the LH side.
59. INSTALL SEAT TRACK COVER LH (for Power Seat)
HINT
Use the same procedures for the RH side and the LH side.
60. INSTALL SEAT TRACK COVER RH (for Power Seat)
HINT
Use the same procedures for the RH side and the LH side.
61. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Power Seat)
62. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) Installation
63. INSTALL INNER SEAT TRACK BRACKET COVER LH (for Manual Seat) Installation
64. INSTALL SEAT TRACK COVER LH (for Manual Seat) Installation
65. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Manual Seat)
66. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)
HINT
Use the same procedures for the RH side and the LH side.
67. INSTALL INNER SEAT TRACK BRACKET COVER RH (for Manual Seat)
HINT
Use the same procedures for the RH side and the LH side.
68. INSTALL SEAT TRACK COVER RH (for Manual Seat)
HINT
Use the same procedures for the RH side and the LH side.
69. REMOVE FRONT SEAT HEADREST ASSEMBLY (for Manual Seat)
70. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
71. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
HINT
Programming and Relearning
72. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System for TMC made, Diagnosis System except TMC made).
73. INSPECT FRONT SEAT ASSEMBLY (for Power Seat) Installation
74. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)