Installation

2AR-FE ENGINE MECHANICAL: DRIVE BELT: INSTALLATION

HINT
The high strength drive belt is used for the generator side drive belt.

When replacing the drive belt, use Toyota genuine drive belt or equivalent high strength drive belt. If the high strength drive belt is not used, durability of the belt may become less than expected. The high strength drive belt is a belt with Aramid core which has higher strength compared to usually available belts with PET or PEN core.

1. INSTALL V-RIBBED BELT (for Compressor and Generator)

(a) Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.





(b) Loosen the V-ribbed belt by turning the belt tensioner clockwise.

(c) Set the V-ribbed belt onto the water pump pulley.

NOTICE:
Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

2. INSTALL V-RIBBED BELT (for Vane Pump)

(a) Set the V-ribbed belt onto each part as shown in the illustration except the tensioner pulley.





(b) Loosen the V-ribbed belt by turning the belt tensioner clockwise.

(c) Set the V-ribbed belt onto the tensioner pulley.

NOTICE:
Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

3. INSTALL FRONT FENDER APRON SEAL RH

4. INSTALL ENGINE UNDER COVER RH

5. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

6. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)