On-Vehicle inspection
METER: METER / GAUGE SYSTEM: ON-VEHICLE INSPECTION
1. INSPECT SPEEDOMETER
(a) Check the operation.
(1) Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.
Reference: mph (U.S.A.)
Reference: km/h (Canada)
NOTICE:
Tire wear as well as over or under inflation will cause errors.
(2) Check the deviation from the acceptable range of the speedometer indication.
Reference:
Less than 0.5 km/h (0.3 mph)
HINT
If the indication is not as specified, go to problem symptoms table Problem Symptoms Table.
2. INSPECT TACHOMETER
(a) Connect a tune-up tachometer, and start the engine.
(b) Compare the test results with the tachometer indications.
DC 13.5 V, at 25°C (77°F)
HINT
If the indication is not as specified, go to the problem symptoms table Problem Symptoms Table.
3. INSPECT ENGINE OIL PRESSURE SWITCH
(a) Disconnect the connector from the engine oil pressure switch.
(b) Turn the ignition switch on (IG).
(c) Ground the terminal of the wire harness side connector, then check the low oil pressure warning light or message.
OK:
HINT
If the warning light or message is not displayed, go to the problem symptoms table Problem Symptoms Table.
4. INSPECT MULTI-INFORMATION DISPLAY
(a) Ignition switch off.
(b) Press the "DISP" button and hold it down.
(c) Ignition switch on (IG).
OK:
All the dots in the multi-information display come on.
HINT
This test is also available on "ACTIVE TEST" Meter / Gauge System.
(d) Ignition switch off to finish this test mode.
HINT
If the result is not as specified, replace the combination meter assembly.