Removal

2AR-FE EXHAUST: EXHAUST MANIFOLD: REMOVAL

1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

3. REMOVE ENGINE UNDER COVER LH

4. REMOVE ENGINE UNDER COVER RH

5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 2 bolts and support bracket.

(d) Remove the 4 nuts, 2 bolts and front exhaust pipe assembly.

(e) Remove the 2 gaskets from the front exhaust pipe assembly and center exhaust pipe assembly.

6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal

7. REMOVE MANIFOLD STAY

(a) Remove the bolt, nut and manifold stay.

8. REMOVE NO. 2 MANIFOLD STAY

(a) Remove the bolt, nut and No. 2 manifold stay.

9. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 4 bolts and No. 1 exhaust manifold heat insulator.

10. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

(a) Remove the 5 nuts and exhaust manifold converter sub-assembly.

11. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 2 bolts and No. 2 exhaust manifold heat insulator.

12. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR

(a) Remove the 4 bolts and No. 1 manifold converter insulator.