Installation

2AR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
* Do not allow foreign matter to contact the lip of the oil seal.
* Do not allow MP grease to contact the dust seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.





SST : 09223-15030

SST : 09950-70010

09951-07150

NOTICE:
* Keep the lip of the oil seal free from foreign matter.
* Do not tap in the oil seal at an angle.

2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-54015

SST : 09330-00021

SST : 91551-80650

(b) Clean the bolts and their installation holes.

(c) Apply a few drops of adhesive to 2 or 3 threads of the bolt end.





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(d) Install the flywheel with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.





Torque : 130 Nm (1326 kgf-cm, 96 ft-lbf)

3. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle) Installation

4. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle) Installation

5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transaxle) Installation

6. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-54015

SST : 91551-80650

SST : 09330-00021

(b) Clean the bolts and their installation holes.

(c) Install the front drive plate spacer.





HINT
Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

(d) Install the drive plate and rear drive plate spacer onto the crankshaft.





(e) Apply a few drops of adhesive to 2 or 3 threads of the 8 bolts.





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(f) Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.





Torque : 98 Nm (999 kgf-cm, 72 ft-lbf)

NOTICE:
Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

7. INSTALL CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY (for Manual Transaxle)

HINT
Installation.

8. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

(a) Install the manual transaxle assembly Installation.

9. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

(a) Install the automatic transaxle assembly Installation.

10. INSTALL ENGINE AND TRANSAXLE

(a) Install the engine and transaxle Installation.