Removal

BRAKE CONTROL: BRAKE ACTUATOR (for BOSCH Made): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE RADIATOR RESERVE TANK ASSEMBLY

(a) Separate the radiator reservoir tank hose.





(b) Remove the radiator reserve tank assembly.





3. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately clean it off completely.

4. REMOVE BRAKE ACTUATOR

(a) Release the lock lever and disconnect the brake actuator connector.





(b) Using union nut wrenches (10 mm and 12 mm), disconnect the 6 brake lines from the brake actuator with brake actuator bracket assembly.





(c) Use tags or make a memo to identify the places to reconnect.

HINT
* *1: To front wheel cylinder RH
* *2: To front wheel cylinder LH
* *3: To rear wheel cylinder RH
* *4: To rear wheel cylinder LH
* *5: From 2nd master cylinder chamber
* *6: From 1st master cylinder chamber





(d) Remove the 3 bolts and brake actuator with bracket from the body.

NOTICE:
Do not damage the brake lines and wire harness.