Removal

BRAKE CONTROL: BRAKE ACTUATOR (for ADVICS Made): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE RADIATOR RESERVE TANK ASSEMBLY

(a) Separate the radiator reserve tank hose.





(b) Remove the radiator reserve tank assembly.





3. DRAIN BRAKE FLUID

NOTICE:
If brake fluid leaks onto any painted surface, immediately clean it off completely.

4. REMOVE BRAKE ACTUATOR

(a) Release the lock lever and disconnect the actuator connector.





(b) Using a union nut wrench (10 mm), disconnect the 6 brake lines from the actuator assembly with bracket.





(c) Use tags or make a memo to identify the places to reconnect.

HINT
* *1: To Front Wheel Cylinder RH
* *2: To Front Wheel Cylinder LH
* *3: To Rear Wheel Cylinder RH
* *4: To Rear Wheel Cylinder LH
* *5: From 1st Master Cylinder
* *6: From 2nd Master Cylinder





(d) Remove the 3 bolts and brake actuator assembly with bracket from the body.

NOTICE:
Do not damage the brake lines and wire harness.