Removal

EXTERIOR: FRONT BUMPER: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL (for 2GR-FE)

(a) Remove the 7 clips and cool air intake duct seal.





2. REMOVE FRONT BUMPER ASSEMBLY

(a) Put protective tape around the front bumper assembly.





(b) Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.





HINT
Use the same procedure for the RH side and LH side.

(c) Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.





(d) Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.





HINT
Use the same procedure for the RH side and LH side.

(e) Remove the front bumper assembly.

(f) w/ Fog Light:

(1) Disconnect each connector, and then remove the front bumper assembly.