USB Device or "iPod" cannot Charge

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: USB Device or "iPod" cannot Charge
- USB Device or "iPod" cannot Charge

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the stereo jack adapter.

(b) Turn the ignition switch off.

HINT
When this malfunction occurs, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

(c) Turn the ignition switch to ACC.

(d) Connect a known good USB device or "iPod" to the stereo jack adapter.

OK:

USB device or "iPod" charges.

NG -- INSPECT MULTI-MEDIA INTERFACE ECU

OK -- USB DEVICE OR "iPod" WAS DEFECTIVE

2. INSPECT MULTI-MEDIA INTERFACE ECU

(a) Disconnect the stereo jack adapter connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- CHECK HARNESS AND CONNECTOR

OK -- REPLACE STEREO JACK ADAPTER Removal

3. CHECK HARNESS AND CONNECTOR

(a) Disconnect the multi-media interface ECU connector.





(b) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table