Removal

NAVIGATION: NAVIGATION ANTENNA CORD: REMOVAL

1. PRECAUTION

Service Precautions

2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

4. REMOVE LOWER NO. 3 STEERING WHEEL COVER Removal

5. REMOVE LOWER NO. 2 STEERING WHEEL COVER Removal

6. REMOVE STEERING PAD Removal

7. REMOVE STEERING WHEEL ASSEMBLY Removal

8. REMOVE FRONT DOOR SCUFF PLATE LH Removal

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) Removal

11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) Removal

12. REMOVE STEERING COLUMN COVER (for TMC Made) Removal

13. REMOVE STEERING COLUMN COVER (for TMMK Made) Removal

14. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Removal

15. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY Removal

16. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System) Removal

17. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System) Removal

18. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1 Removal

19. REMOVE COMBINATION METER ASSEMBLY (for TMC Made) Removal

20. REMOVE COMBINATION METER ASSEMBLY (for TMMK Made) Removal

21. REMOVE FRONT DOOR SCUFF PLATE RH Removal

22. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

23. REMOVE INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY Removal

24. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMC Made) Removal

25. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for TMMK Made) Removal

26. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) Removal

27. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) Removal

28. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

29. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

30. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle) Removal

31. REMOVE UPPER CONSOLE PANEL (for Manual Transaxle) Removal

32. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle) Removal

33. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle) Removal

34. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMC Made) Removal

35. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for TMMK Made) Removal

36. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY Removal

37. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY Removal

38. REMOVE CONSOLE BOX POCKET Removal

39. REMOVE CONSOLE BOX CARPET Removal

40. REMOVE CONSOLE BOX ASSEMBLY (for TMC Made) Removal

41. REMOVE CONSOLE BOX ASSEMBLY (for TMMK Made) Removal

42. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMC Made) Removal

43. REMOVE NO. 2 CONSOLE BOX INSERT FRONT (for TMMK Made) Removal

44. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMC Made) Removal

45. REMOVE NO. 1 CONSOLE BOX INSERT FRONT (for TMMK Made) Removal

46. REMOVE FRONT PILLAR GARNISH LH Removal

47. REMOVE INSTRUMENT PANEL NO. 1 REGISTER ASSEMBLY Removal

48. REMOVE INSTRUMENT PANEL NO. 1 SPEAKER PANEL SUB-ASSEMBLY Removal

49. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for LH Side) Removal

50. REMOVE FRONT PILLAR GARNISH RH Removal

51. REMOVE INSTRUMENT PANEL NO. 3 REGISTER ASSEMBLY Removal

52. REMOVE INSTRUMENT PANEL NO. 2 SPEAKER PANEL SUB-ASSEMBLY Removal

53. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (for RH Side)

HINT
Use the same procedures for the RH side and the LH side Removal.

54. REMOVE NO. 1 DEFROSTER NOZZLE GARNISH Removal

55. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMC Made) Removal

56. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY (for TMMK Made) Removal

57. REMOVE NO. 3 INSTRUMENT PANEL STAY Removal

58. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMC Made) Disassembly

59. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT (for TMMK Made) Disassembly

60. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMC Made) Disassembly

61. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT (for TMMK Made) Disassembly

62. REMOVE DEFROSTER NOZZLE ASSEMBLY (for TMC Made) Disassembly

63. REMOVE DEFROSTER NOZZLE ASSEMBLY (for TMMK Made) Disassembly

64. REMOVE NO. 1 HEATER TO REGISTER DUCT (for TMC Made) Disassembly

65. REMOVE NO. 1 HEATER TO REGISTER DUCT (for TMMK Made) Disassembly

66. REMOVE NO. 3 HEATER TO REGISTER DUCT (for TMC Made) Disassembly

67. REMOVE NO. 3 HEATER TO REGISTER DUCT (for TMMK Made) Disassembly

68. REMOVE NO. 2 HEATER TO REGISTER DUCT (for TMC Made) Disassembly

69. REMOVE NO. 2 HEATER TO REGISTER DUCT (for TMMK Made) Disassembly

70. REMOVE NAVIGATION ANTENNA ASSEMBLY

(a) Disengage the 3 clamps.





(b) Remove the 2 screws and navigation antenna assembly.