Rear Power Window Motor RH Circuit

WINDSHIELD / WINDOW GLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window Motor RH Circuit
- Rear Power Window Motor RH Circuit

DESCRIPTION

This circuit transmits signal from the multiplex network switch assembly (rear RH side) to the power window regulator motor assembly (rear RH side).

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR (REAR RH)

(a) Remove the power window regulator motor.





(b) Apply battery voltage to the motor connector according to the table below.

NOTICE:
Do not apply battery voltage to any terminals except terminals 1 and 2.

Standard:





NG -- REPLACE POWER WINDOW REGULATOR MOTOR (REAR RH)
OK -- Continue to next step.

2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - POWER WINDOW REGULATOR SWITCH)

(a) Disconnect the I2 and I4 connectors.

(b) Measure the resistance of the wire harness side connectors.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE